Community

SCI Programming => Mega Tokyo SCI Archive => Topic started by: Chris Cromer on September 07, 2002, 09:32:04 AM

Title: Problem with SCI VGA view
Post by: Chris Cromer on September 07, 2002, 09:32:04 AM

I have been having a problem with a specefic view in the SCI VGA view editor, after I save it, the second cel in this view gets distorted a bit at the bottom, no matter how many times I fix it and save it, when I load it again the distortion is back.

The view is at http://www.agigames.com/walking.zip

Anyway to get past this? All of my other views work just fine, this is the only view that does this.

Proabably a bug in the view editor, so hopefully it will be fixed.

Title: Re:Problem with SCI VGA view
Post by: juncmodule on September 07, 2002, 10:27:21 AM

? I think I'm missing something. Was that SCI *VGA* View Editor?

Title: Re:Problem with SCI VGA view
Post by: Chris Cromer on September 07, 2002, 10:29:22 AM

Yes it IS the SCI VGA View editor. I am making VGA views.

Title: Re:Problem with SCI VGA view
Post by: Brian Provinciano on September 07, 2002, 10:32:22 AM

All of my VGA tools other than the compiler are untouched up versions with many flaws, and most unreleased. I'm not going to bother releasing a new version until SCI Studio VGA. The current version I've done, though more functional, has more loose ends too.

Title: Re:Problem with SCI VGA view
Post by: Chris Cromer on September 07, 2002, 10:34:00 AM

Oh well, at least most of the views come out ok, only 2 views so far have had distortion, and they only distort at the bottom of the view.

Well anyway, good luck with SCI Studio VGA, can't wait to see it. :)

Title: Re:Problem with SCI VGA view
Post by: Brian Provinciano on September 07, 2002, 11:10:15 AM

It was my 8bit VGA compression code, which I have since fixed. I ironed it out for my picture editor, then copied and pasted :)